The multi-award winning Chillipeeps adapter solves a common problem many people experience when out and about with young hungry babies and no clean sterilised bottle to use, by allowing a teat or spout to be attached directly to all ready formula cartons and Aptamil and Cow&Gate ready made formula bottles to feed your baby and Volvic and Evian water bottles to enable you to rehydrate your baby.
The idea was born In Yorkshire, when Claire had set off to a family party with her baby, she knew she had a carton of ready-made formula in the car but couldn't remember if she picked up the clean sterilised bottle. Knowing her baby would need a feed whilst she was out, she asked her husband to check for the bottle while she wondered why no-one had invented anything that could attach directly to the carton. Eureka!
The Chillipeeps adapter comes in two variants, the Chillipeeps NEW 3in1 teat and the Chillipeeps NEW 3in1 spout.
The multi-award winning Chillipeeps NEW 3in1 Spout attaches to Aptamil and Cow&Gate ready-made formula bottles; all ready-made formula cartons and Evian and Volvic water bottles, perfect for when you are out and about with your baby.
Only give milk and water to babies to prevent tooth decay.
Suitable for 6 months and 12 months+
How to use.
The Chillipeeps Teat & Spout are suitable for ready-made formula milk cartons and bottled mineral water, to prevent tooth decay only give milk and water.
Fits all cartons of ready-made formula milk: To attach, remove bottom pod, ensure the carton is clean, gently pierce and screw in. As soon as you feel resistance stop. Do not over-tighten onto the carton, this could break the seal with the carton and cause leakage
Fits Aptamil and Cow&Gate ready-made formula 200ml bottles: To attach, remove the bottom pod and both bottom plates and attach directly to the bottle
Fits Volvic and Evian 500ml / 50cl bottles: To attach, remove the bottom pod and bottom plate with screw thread and attach directly to the bottle in replacement or their lid.
Which bottled water does the Chillipeeps adapter fit? The Chillipeeps adapter does not fit all bottles. It fits Evian, Volvic and Highland Spring, these bottled waters have less than 200 milligrams (mg) a litre of sodium (also written as Na) and less than 250mg a litre of sulphate (also written as SO or SO4)
The teat / spout in a pod is easy to attach, use, remove, clean and sterilise ready for the next drink.
How can the Chillipeeps adapter be sterilised? To sterilise the Chillipeeps adapter, you must dismantle it, wash it and place dismantled into your steriliser and then re-assemble after sterilising. The Chillipeeps is approved to be used in the dishwasher, sterilising solution and steam sterilisers.
